fc488eef01
The port ran on whichever hart the firmware handed over on, with a single idle stack. The firmware does not pick the same hart every boot, so nothing may assume one. The hart that arrives first records which it was, indexes its idle stack by its own ID, and restarts on hart 0; NuttX runs CPU0 there because that is the only hart riscv_set_inital_sp() gives a whole idle stack to. The first hart in owns the one time setup, and that guard lives in .data because it is read before the BSS is cleared. CONFIG_SMP_NCPUS below four is refused in chip.h: the hart the firmware picked would have no slot and would stop in __start before it could restart, which fails on some resets and not others. Secondary harts are released through the common SBI helper rather than a private copy of the same call. Assisted-by: Claude:claude-opus-5 Signed-off-by: Justin Hammond <justin@dynam.ac> |
||
|---|---|---|
| .github | ||
| arch | ||
| audio | ||
| binfmt | ||
| boards | ||
| cmake | ||
| crypto | ||
| Documentation | ||
| drivers | ||
| dummy | ||
| fs | ||
| graphics | ||
| include | ||
| libs | ||
| mm | ||
| net | ||
| openamp | ||
| pass1 | ||
| sched | ||
| syscall | ||
| tools | ||
| video | ||
| wireless | ||
| .asf.yaml | ||
| .codespell-ignore-lines | ||
| .codespellrc | ||
| .editorconfig | ||
| .gitignore | ||
| .gitmessage | ||
| .pre-commit-config.yaml | ||
| .yamllint | ||
| AUTHORS | ||
| CMakeLists.txt | ||
| CONTRIBUTING.md | ||
| INVIOLABLES.md | ||
| Kconfig | ||
| LICENSE | ||
| Makefile | ||
| NOTICE | ||
| README.md | ||
| ReleaseNotes | ||
Apache NuttX is a real-time operating system (RTOS) with an emphasis on standards compliance and small footprint. Scalable from 8-bit to 64-bit microcontroller environments, the primary governing standards in NuttX are POSIX and ANSI standards. Additional standard APIs from Unix and other common RTOSs (such as VxWorks) are adopted for functionality not available under these standards, or for functionality that is not appropriate for deeply-embedded environments (such as fork()).
For brevity, many parts of the documentation will refer to Apache NuttX as simply NuttX.
Getting Started
First time on NuttX? Read the Getting Started guide! If you don't have a board available, NuttX has its own simulator that you can run on terminal.
Documentation
You can find the current NuttX documentation on the Documentation Page.
Alternatively, you can build the documentation yourself by following the Documentation Build Instructions.
The old NuttX documentation is still available in the Apache wiki.
Supported Boards
NuttX supports a wide variety of platforms. See the full list on the Supported Platforms page.
Contributing
If you wish to contribute to the NuttX project, read the Contributing guidelines for information on Git usage, coding standard, workflow and the NuttX principles.
License
The code in this repository is under either the Apache 2 license, or a license compatible with the Apache 2 license. See the License Page for more information.