mirror of
https://github.com/apache/nuttx.git
synced 2026-09-30 02:53:49 +00:00
ec7ee53f6f
Expose the RTL8730E general-purpose UARTs through the shared Ameba serial driver (arch/arm/src/common/ameba/ameba_uart.c) by adding the chip-specific glue, build wiring and a board port table. The change is gated by CONFIG_AMEBA_UART (default disabled); the LOG-UART keeps the console and /dev/ttyS0. Chip glue (ameba_uart_chip.h) supplies the three UART controller register bases, GIC IRQ numbers (SPI 50/51/52 -> NuttX IRQ 82/83/84), APB clock masks and pin-mux codes. The board registers UART0-2 as /dev/ttyS1-3 at 115200 8N1; UART3 is reserved for Bluetooth. Pads are picked from the EVB break-out (the UART crossbar maps each controller to many pads, so this is purely a board choice). Also fix an RX-timeout interrupt storm in the shared driver: the RX-timeout status (LSR bit9) is latched and is not cleared by draining the RX FIFO, so on a level-triggered GIC (RTL8730E) the ISR must explicitly write TOICF, matching the vendor SDK serial_api.c. The extra register write is harmless on the NVIC-based M33 Ameba parts and was regression-tested on them. Signed-off-by: dechao_gong <dechao_gong@realsil.com.cn> Assisted-by: Claude <noreply@anthropic.com> |
||
|---|---|---|
| .. | ||
| arm | ||
| arm64 | ||
| avr | ||
| ceva | ||
| dummy | ||
| hc | ||
| mips | ||
| misoc | ||
| or1k | ||
| renesas | ||
| risc-v | ||
| sim | ||
| sparc | ||
| tricore | ||
| x86 | ||
| x86_64 | ||
| xtensa | ||
| z16 | ||
| z80 | ||
| CMakeLists.txt | ||
| Kconfig | ||