mirror of
https://github.com/apache/nuttx.git
synced 2026-08-01 20:28:58 +00:00
d960bc39ee
Some checks are pending
Build Documentation / build-html (push) Waiting to run
MemBrowse Memory Report / changes-filter (push) Waiting to run
MemBrowse Memory Report / load-targets (push) Waiting to run
MemBrowse Memory Report / identical (push) Blocked by required conditions
MemBrowse Memory Report / analyze (push) Blocked by required conditions
Wire the shared Ameba GPIO driver into the RTL8721F (amebagreen2) build and
add the EVB board glue:
- arch/arm/src/rtl8721f: build ameba_gpio.c (CMake/Make.defs), source the
common Ameba Kconfig, and add ameba_gpio_chip.h describing the chip's
three GPIO ports (A/B/C), their IRQs and the APBPeriph clock bit.
- arch/arm/src/common/ameba: teach the driver that amebagreen2's ROM
GPIO_Init does not call PAD_PullCtrl or GPIO_INTMode, so call both
explicitly after GPIO_Init; on RTL8721Dx (ram_common) these are harmless
redundant writes. Add the AMEBA_PORT_C / AMEBA_PC() helpers.
- boards/arm/rtl8721f/rtl8721f_evb: register output/input/interrupt demo
pins, add the bringup hook, and provide a minimal 'gpio' NSH defconfig.
- Documentation: add a GPIO section for the RTL8721F EVB and fix a
rising/falling typo in the PKE8721DAF page.
Hardware-verified on the RTL8721F EVB: output, input, and all interrupt
trigger/polarity combinations (rising/falling edge, level high/low).
Signed-off-by: dechao_gong <dechao_gong@realsil.com.cn>
Assisted-by: Claude <noreply@anthropic.com>
|
||
|---|---|---|
| .. | ||
| arm | ||
| arm64 | ||
| avr | ||
| ceva | ||
| hc | ||
| mips | ||
| misco | ||
| or1k | ||
| renesas | ||
| risc-v | ||
| sim | ||
| sparc | ||
| tricore | ||
| x86 | ||
| x86_64 | ||
| xtensa | ||
| z16 | ||
| z80 | ||
| index.rst | ||