- The frequency step was truncated to 61 Hz, while it is FXOSC/(2**19),
about 61.035 Hz. The error puts a 915 MHz channel more than 500 kHz away
from the requested frequency, outside its own bandwidth.
- The low or high frequency front end was left at its reset value, so a board
wired for 868 or 915 MHz neither transmitted nor received.
- sx127x_rx_watchdog() is only used by the FSK and OOK path but was compiled
whenever receive support was on, so a LoRa only configuration failed to
build with -Werror. nrf52840-dk:sx127x is such a configuration.
Adds the sync word, the default bandwidth and the default spreading factor as
configuration options, all defaulting to the previous behaviour, and a page
for the driver under components/drivers.
Assisted-by: Claude Code 4.8
Signed-off-by: Jorge Guzman <jorge.gzm@gmail.com>
Character driver for the Semtech SX1301, the baseband processor of a LoRaWAN
gateway, and the two SX125x radios it drives. Received packets come from
read(), downlinks go to write(), and the channel plan, the start and the stop
are ioctls.
The interface is device independent, in nuttx/wireless/lpwan/lora_gw.h with
the commands in the common WLIOC_GW_* space, so another concentrator driver
can implement it and the same application drive it.
Adds a lorawan_gw configuration for the Nucleo F746ZG with a shield of the
LRWAN_GS_HF1 family. Off by default (LPWAN_SX1301).
Assisted-by: Claude Code 4.8
Signed-off-by: Jorge Guzman <jorge.gzm@gmail.com>
Adds initial documentation to the IOCTL commands of wireless character devices.
Signed-off-by: Kevin Witteveen (MartiniMarter) <kevinwit1999@gmail.com>
Added detailed information about the SX126x and its current state in development.
Added directories for wireless character driver and LPWAN.
Added indexes to each directory and its contents within.
Signed-off-by: Kevin Witteveen (MartiniMarter) <kevinwit1999@gmail.com>
