mirror of
https://github.com/apache/nuttx.git
synced 2026-10-13 01:00:12 +00:00
d938fdbb00
A connection stops the legacy advertising set and the vendor stack leaves it stopped, so after the first central connected (or aborted the attempt) the device was never discoverable again until a reset. Register a connection callback and restart the advertising set with ble_adv_restart() on every disconnection event. This covers both the clean disconnect and the aborted-connection case: an incomplete connection holds the (single) link until the supervision timeout, and its disconnection event then restarts the advertising the same way. Validated on hardware (GD32VW553K-START): repeated scan/connect/write/disconnect cycles from a Linux central all find the device advertising again after the previous cycle, where it previously required a reset after the first connection. Assisted-by: Claude Opus 4.8 Signed-off-by: Jorge Guzman <jorge.gzm@gmail.com> |
||
|---|---|---|
| .. | ||
| arm | ||
| arm64 | ||
| avr | ||
| ceva | ||
| hc | ||
| mips | ||
| misco | ||
| or1k | ||
| renesas | ||
| risc-v | ||
| sim | ||
| sparc | ||
| tricore | ||
| x86 | ||
| x86_64 | ||
| xtensa | ||
| z16 | ||
| z80 | ||
| index.rst | ||