Gregory Nutt 41666dafa8 drivers/usbhost/usbhost_max3421e.c: Fix an error in reading the pending interrupts. Aos fix a number of typos and update a README.		2018-07-29 15:06:44 -06:00
..
1wire	ds28e17.h edited online with Bitbucket	2018-04-05 12:08:56 +00:00
analog
audio	Adds loopback test for digital MIC on lc823450 via i2schar driver.	2018-06-05 10:34:22 -06:00
binfmt
can	arch/arm/src/samv7: Add ability for CAN BUS_OFF autorecovery according ISO11898-1:2015. With this change we added an ioctl for triggering the autorecovery sequence for BUS_OFF to the CAN-driver and the SAMV7 low-level driver. According the datasheet: If the device goes Bus_Off, it will set MCAN_CCCR.INIT of its own accord, stopping all bus activities. Once MCAN_CCCR.INIT has been cleared by the processor (application), the device will then wait for 129 occurrences of Bus Idle (129 * 11 consecutive recessive bits) before resuming normal operation. At the end of the Bus_Off recovery sequence, the Error Management Counters will be reset. During the waiting time after the resetting of MCAN_CCCR.INIT, each time a sequence of 11 recessive bits has been monitored, a Bit0 Error code is written to MCAN_PSR.LEC, enabling the processor to readily check up whether the CAN bus is stuck at dominant or continuously disturbed and to monitor the Bus_Off recovery sequence. MCAN_ECR.REC is used to count these sequences.	2018-07-04 07:48:59 -06:00
contactless
crypto
drivers	This commit adds a 1wire subsystem.	2018-04-04 10:57:36 -06:00
eeprom
fs	include/nuttx/fs/hostfs.h: Update duplicated definitions in HOSTFS that must match NuttX values.	2018-07-09 05:44:48 -06:00
i2c	i2c/i2c_master.h: Change incorrect comment about I2C_TRANSFER return value to indicate that the method returns zero on success rather than the number of bytes transferred.	2018-03-22 06:51:09 -06:00
input
ioexpander
lcd	drivers/lcd and configs/olimex-lpc1766stk: Remove support for the Nokia6100 LCD. That LCD uses a 9-bit SPI interface (the 9th bit being the command/data bit that is normally a discrete). That communication was never successfully integrated. I now believe that it would would require some special support from the low-level, MCU SPI driver to manage that 9th bit. The deleted code is still available in the Obsoleted repository in the nuttx/drivers/lcd, nuttx/configs/olimex-lpc1766stk, and Patches directories.	2018-05-19 16:46:21 -06:00
leds	Squashed commit of the following:	2018-07-22 15:13:39 -06:00
lib
mm	net/tcp: Re-think CONFIG_NET_TCP_RWND_CONTROL TCP windowing controls.	2018-06-24 14:46:12 -06:00
modem
mtd	/include/nuttx/mtd/configdata.h: Fix copy-paste comment in configdata.h	2018-05-08 09:09:47 -06:00
net	Small update to some comments.	2018-07-19 09:09:53 -06:00
nx
power	Merged in raiden00/nuttx (pull request #668)	2018-07-07 17:04:57 +00:00
sensors	include/nuttx/sensors/bh1750fvi.h: Eliminate a warning.	2018-07-15 07:20:07 -06:00
serial
spi	include/nuttx/spi/spi.h: Add a definition for a USBHOST SPI device. drivers/usbhost/usbhost_max3421e.c: Review and correct SPI locking usage.	2018-07-04 08:55:43 -06:00
syslog	syslog: Enable is partial, crippled version of syslog_flush(); arch/: Call syslog_flush() from assertion handling logic.	2018-06-07 16:29:16 -06:00
timers	Update some comments.	2018-07-22 05:56:11 -06:00
usb	drivers/usbhost/usbhost_max3421e.c: Fix an error in reading the pending interrupts. Aos fix a number of typos and update a README.	2018-07-29 15:06:44 -06:00
video	Fix lots of typos in C comments and Kconfig help text	2018-07-08 18:24:45 -06:00
wireless	include/nuttx/wireless/bluetooth: Move Bluetooth header files from include/nuttx/wireless to include/nuttx/wireless/bluetooth for symmetry with other wireless technologies.	2018-04-29 12:43:09 -06:00
.gitignore
addrenv.h
arch.h
ascii.h
board.h
cancelpt.h
clock.h	Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t	2018-06-16 12:16:13 -06:00
compiler.h
init.h
irq.h
kmalloc.h
kthread.h
mmcsd.h
module.h
mqueue.h
page.h
pgalloc.h
poff.h
progmem.h	progmem interface: Discern r/w and erase page sizes. Introduce new up_progmem_erasesize architecture API to be able to communicate the read/write page size independently from erase page size. Implement up_progmem_erasesize for all architectures that already support progmem, assuming that for those architectures the sizes of both read/write and erase pages are identical.	2018-05-01 06:23:52 -06:00
pthread.h
random.h
sched.h	Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t	2018-06-16 12:16:13 -06:00
sched_note.h
scsi.h
sdio.h
semaphore.h	Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t	2018-06-16 12:16:13 -06:00
signal.h	Fix lots of typos in C comments and Kconfig help text	2018-07-08 18:24:45 -06:00
spawn.h
spinlock.h
streams.h
symtab.h
time.h
tls.h
tree.h
userspace.h
vt100.h
wdog.h
wqueue.h	Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t	2018-06-16 12:16:13 -06:00
zoneinfo.h