8c8ae92530
The STM32F072RB provides a full speed USB device controller, but the Nucleo-F072RB board support did not enable it and no configuration exercised it. Add the pieces required to run USB device mode on this board: - Select HSI48 as the 48MHz source and use the USB start of frame packet as the CRS synchronisation event, which is the intended crystal-less USB configuration for this part. - Add the USB device pin definitions to the STM32F07x pin map. - Provide board level pull-up control and register the CDC/ACM class at boot when it is selected. - Add a usb-cdc-uart configuration that presents an NSH console on USART2 and a CDC/ACM serial device on USB. - Enable the USB device pins in the nsh configuration so the two configurations stay consistent. Assisted-by: GitHub Copilot:claude-opus-5 Signed-off-by: jsanchez-2g <jsanchez@2g-eng.com> |
||
|---|---|---|
| .github | ||
| arch | ||
| audio | ||
| binfmt | ||
| boards | ||
| cmake | ||
| crypto | ||
| Documentation | ||
| drivers | ||
| dummy | ||
| fs | ||
| graphics | ||
| include | ||
| libs | ||
| mm | ||
| net | ||
| openamp | ||
| pass1 | ||
| sched | ||
| syscall | ||
| tools | ||
| video | ||
| wireless | ||
| .asf.yaml | ||
| .codespell-ignore-lines | ||
| .codespellrc | ||
| .editorconfig | ||
| .gitignore | ||
| .gitmessage | ||
| .pre-commit-config.yaml | ||
| .yamllint | ||
| AUTHORS | ||
| CMakeLists.txt | ||
| CONTRIBUTING.md | ||
| INVIOLABLES.md | ||
| Kconfig | ||
| LICENSE | ||
| Makefile | ||
| NOTICE | ||
| README.md | ||
| ReleaseNotes | ||
Apache NuttX is a real-time operating system (RTOS) with an emphasis on standards compliance and small footprint. Scalable from 8-bit to 64-bit microcontroller environments, the primary governing standards in NuttX are POSIX and ANSI standards. Additional standard APIs from Unix and other common RTOSs (such as VxWorks) are adopted for functionality not available under these standards, or for functionality that is not appropriate for deeply-embedded environments (such as fork()).
For brevity, many parts of the documentation will refer to Apache NuttX as simply NuttX.
Getting Started
First time on NuttX? Read the Getting Started guide! If you don't have a board available, NuttX has its own simulator that you can run on terminal.
Documentation
You can find the current NuttX documentation on the Documentation Page.
Alternatively, you can build the documentation yourself by following the Documentation Build Instructions.
The old NuttX documentation is still available in the Apache wiki.
Supported Boards
NuttX supports a wide variety of platforms. See the full list on the Supported Platforms page.
Contributing
If you wish to contribute to the NuttX project, read the Contributing guidelines for information on Git usage, coding standard, workflow and the NuttX principles.
License
The code in this repository is under either the Apache 2 license, or a license compatible with the Apache 2 license. See the License Page for more information.