Modifies Kconfig and build tools to support flash encryption
and E-Fuse burning when flash encryption is enabled.
Signed-off-by: Filipe Cavalcanti <filipe.cavalcanti@espressif.com>
This commit fixes E-Fuse driver to get proper block and bit offset.
Also adds support for virtual and flash E-Fuses.
Signed-off-by: Filipe Cavalcanti <filipe.cavalcanti@espressif.com>
This commit simplifies the selection of the SPI flash frequency for
Espressif SoCs by using a standardized Kconfig-defined macro.
Signed-off-by: Tiago Medicci Serrano <tiago.medicci@espressif.com>
The default frequency for the SPI flash chip on ESP32-H2 is 64MHz.
Although it was being set to 48MHz, this isn't a valid value. The
device, however, must be flashed using 48MHz when 64MHz is set.
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
For newer devices, IDF bootloader is not supported because the
devices are able to boot directly into NuttX or use MCUBoot to
enable OTA and security features.
The Simple Boot feature for Espressif chips is a method of booting
that doesn't depend on a 2nd stage bootloader. Its not the
intention to replace a 2nd stage bootloader such as MCUboot and
ESP-IDF bootloader, but to have a minimal and straight-forward way
of booting, and also simplify the building.
This commit also removes deprecated code and makes this bootloader
configuration as default for esp32s2 targets and removes the need
for running 'make bootloader' command for it.
Signed-off-by: Almir Okato <almir.okato@espressif.com>
The Simple Boot feature for Espressif chips is a method of booting
that doesn't depend on a 2nd stage bootloader. Its not the
intention to replace a 2nd stage bootloader such as MCUboot and
ESP-IDF bootloader, but to have a minimal and straight-forward way
of booting, and also simplify the building.
This commit also makes this bootloader configuration as default
for esp32c3-generic target and removes the need for running
'make bootloader' command for it.
Signed-off-by: Almir Okato <almir.okato@espressif.com>
Initially supporting ESP32-C3 chip, to be followed by other RISC-V-based
chips from Espressif.
Signed-off-by: Gustavo Henrique Nihei <gustavo.nihei@espressif.com>
