On K3 SoCs the A53 cluster does not own device power, clocks, resets or
interrupt routing; these are managed by the DM/TIFS firmware and requested
over TISCI through the secure-proxy mailbox. Add:
- a TISCI client (secure-proxy transport plus device/clock/reset helpers)
- a GPIO driver for banks 0/1 with pad mux and TISCI power-on
- an OMAP-I2C driver for the main-domain I2C controllers
and wire them into the PocketBeagle2 and BeaglePlay bring-up.
Tested on PocketBeagle2 (SYSFW 11.2.5) with the TechLab cape attached:
nsh> i2c bus
nsh> i2c dev -b 0 0x03 0x77 # I2C0 detects onboard 0x20 and 0x50
nsh> gpio -o 1 /dev/gpio3 # drives a user LED; read back with:
nsh> gpio /dev/gpio3
Signed-off-by: Piyush Patle <piyushpatle228@gmail.com>
Add the AM62x architecture support needed to boot NuttX on TI K3
AM62x platforms. This includes the chip integration, memory map, IRQ
definitions, low-level console support, boot code, and the AM62x 16550
serial lower half.
Signed-off-by: Piyush Patle <piyushpatle228@gmail.com>
